How To Strip And Refinish A Wood Floor

August 05, 2021

Go over the whole floor and set all nails below the surface of the wood, but don’t fill them. Sanding along the edges of the floorboards requires using the edger you hired earlier.

refinishing wood floors one room at a time Refinishing

The hardwood floor refinishing process is easier and less expensive than sanding down to bare wood and takes less.

How to strip and refinish a wood floor. An orbital or belt sander also won’t reach the edges properly. When you reach the wall, return to the center of the room and sand the next section, until you sand the entire wood floor. If you do it yourself, it will cost about $1 per square foot.

Again make sure you do this slowly and methodically, going around the edge of the floor with the pipe of. Vacuum, then wipe with a damp cloth. Sanding and refinishing hardwood floors costs $1.50 to $5.00 per square foot for labor and materials.

Never sand it or the look of the floor will be ruined. After sanding, contractors apply multiple coats of clear finish seal and protect the floor. The purpose of this is to key the surface to allow the new coat to bond to the floor and prevent the new coat peeling off.

That’s 600 square feet, or $600 if you do it yourself versus perhaps $2,400 if. Whether you've been admiring your old wood floor for years or you just discovered it hidden under some old carpeting, refinishing it can be a feast for. Apply 1 coat of bona novia (satin).

It is fine to paint over the caulk between the boards. To buff out a small scratch in your floor polish by hand, rub brass wool over the damage until the scratch or ding has been leveled out and you can’t see it anymore. The cost for having a professional refinish a hardwood floor runs about $3.50 to $4 per square foot.

Read on to see how one expert weighed his options and made the right move. You barely have to even go over the floor. Sanding removes the old finish and the surface layer of the wood to eliminate scratches, dings, and discoloration.

Turn on the sander and slowly work it back and forth across the entire room. Whereas, installing a few coats of polyurethane can give you the appearance of natural wood and is what most seek in a finish — just be sure to have samples of low, semi, and high gloss to compare. Properly applied, the caulk will.

A drum sander will only get to within a few inches of your walls. Let’s consider a room that’s 30 feet by 20 feet. You may have to strip the floor first and then sand out the gray spots.

Expect to spend in the ballpark of: Apply the solvent with a rag to loosen the shellac/lacquer from the wood surface, then lightly scrape the residual finish with a plastic putty knife. Apply a coat of the bona novia satin the same way you did the sealer by edging and rolling (using a new roller).

There are pros and cons to either choice. (again i left it overnight). Deciding whether to refinish or replace the wood floor in your home?

Allow to dry 3 hours. Caulk left on the floor becomes sandwiched between the wood and paint and will move independently, causing the paint to crack. Based on the cost of material is your floor worth refinishing this way or would you be better off replacing the floor altogether?

Vacuum the floor again and sand it.

How to Remove Laminate Flooring Refinish wood floors